what are you looking for?
Popular Searches
Maybe there is too much invite data from JustINA, which cause packet discarded. Please contact us for JustINA upgrade.
Access FXS by telnet. After entering the config mode, enter the command “inet gateway-ping stop”.
Go to “Advanced-FXO Parameter”. Set the “Format of From filed when CID is Available” as “CID/CID”. And make sure the phone line support “Caller ID”.
Go to “Advanced>Service Parameter”,decrease the time of “Timeout for Dialing”.
Maybe there are too many voice codecs carried by 8070, causing the FXS not responding. Only 729(PCMA) and 711(PCMU) two codes sent by IP phone, only enable these two codec on IPPBX.
You can pick up an analog phone, and then press ‘*158#’, you will hear the FXS’s IP from the call.
‘*158#’ for announcing the device’s IP.
‘*114#’ for announcing account number at this port.
‘*72*’ + number for always forwarding call the number.
‘*73#’ for call forward cancel.
Mon ~ Fri: 9:00 ~ 19:00
9th Floor, Haohai Office Building, Haidian District, Beijing
zchen@equiinet.cn
